NOTES:

  • . FOLLOW STEPS ONE THROUGH TWELVE BELOW TO SET THE ICE MAKER FOR THE TEST.

  • .THE ICEMAKER CONTROL MUST BE IN THE "ON" POSITION.

  • . THE ICE BIN MUST BE ON THE DOOR AND THE ICE LEVEL BELOW THE NOTCHED OPENINGS.

  • .THE ICE MAKER MUST BE IN HARVEST IMMEDIATELY AFTER THE WATER FILL.

 

     Unplug refrigerator or disconnect power,

2. Slide icemaker out, remove cover.

3. Jump "T_H" to start a harvest.

4. Plug in refrigerator or reconnect power.

5. Close the freezer door to align the optics and a harvest cycle will begin in 5 seconds.

6. Open the freezer door and observe l/M. A harvest should be in progress.

       lf "T" to "H" is properly jumped and the icernaker won't run, stop test and check the icemaker

7. Unplug refrigerator or disconnect power.

8. Remove the jumper before the fingers reach 10:00. Reinstall icemaker or be prepared to catch the water in step 10.

9. Plug in refrigerator or reconnect power.

10. Listen for the water fill and disconnect the power immediately after the fill.

11. With the freezer door closed, reconnect the power.

12. Wait 5 seconds to a maximum of 50 seconds, open the freezer door and watch the LED.

 

4 pulses,

repeated once,

indicates a

failed relay.

Replace both

optics boards.

 

3 pulses,

repeated once,

indicates optics

and relay are

good but, l/M is

not being

sensed/will not

operate.

. * Check l/M

components.

. * Check l/M

circuit and

connections

back to the

receiver board

and neutral.

 

2 pulses,

repeated once,

indicate the

optics are failed.

Replace both

optics boards,

 

Steady light for 5 seconds indicates

the relay and

optics are good,

and the receiver

senses the

icemaker in the

circuit.

 

No light Unplug

refrigerator for 5

seconds and repeat

test.-